Robotics COURIER Technical Information PDF herunterladen (Seite 62)

7-6 Courier I-modem Getting Started Guide

d Set the Call Type.

Note: The call type you choose will apply to both

incoming and outgoing calls.

The command is AT*V2=n

To set this call rype Use this command

Automatic service choice

(Universal Connect)

AT*V2=0

V.120 rate adaption calls only AT*V2=1

V.110 rate adaption calls only AT*V2=2

Modem or fax emulation only AT*V2=3

Clear-channel synchronous calls

only

AT*V2=4

Internet access mode (default) AT*V2=5

You are done configuring your I-modem.

Step Two: Checking the Configuration

Send ATI12 <Enter>, and check that the settings you made are

correct.

Step Three: Saving the Configuration

Reset the I-modem by sending ATZ! <Enter> or power off the

modem and power it on again.

Sending ATZ is not sufficient! Send ATZ! <Enter> Your settings

will not take effect until the I-modem undergoes this type of reset.

Note: If your phone company requires compliance with Bellcore

Special Report NWT 1953, which introduces a random delay of 45 to

65 seconds when bringing up your line, you can set the I-modem to

comply by sending ATS67.4=1 <Enter>. To disable compliance, send

ATS67.4=0 <Enter>.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 150 151

Keine Kommentare

Robotics COURIER Technical Information Seite 62