Robotics Sportster Flash x2 Betriebsanweisung PDF herunterladen (Seite 57)

User’s Guide & Reference 53

S-Registers

To change a setting, use the ATSr=n command, where r is

the register and n is a decimal value from 0 − 255

(unless otherwise indicated).

S0 0 Sets the number of rings on which to answer in

Auto Answer Mode. When set to 0, Auto Answer

is disabled.

S1 0 Counts and stores the number of rings from an

incoming call. (S0 must be greater than 0.)

S2 43 Stores the ASCII decimal code for the escape

code character. Default character is +. A value

of 128 – 255 disables the escape code.

S3 13 Stores the ASCII code for the Carriage Return

character. Valid range is 0 – 127.

S4 10 Stores the ASCII decimal code for the Line Feed

character. Valid range is 0 – 127.

S5 8 Stores the ASCII decimal code for the

Backspace character. A value of 128−255

disables the Backspace key’s delete function.

S6 2 Sets the number of seconds the modem waits

before dialing. If Xn is set to X2 or X4, this is the

time-out length if there isn't a dial tone.

S7 60 Sets the number of seconds the modem waits for

a carrier. May be set for much longer duration if,

for example, the modem is originating an

international connection.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 69 70

Keine Kommentare

Robotics Sportster Flash x2 Betriebsanweisung Seite 57